SparkTip
A cordless soldering iron kit for beginners
Safety Instructions
This product is an electrical appliance that uses high current to achieve heating function. Please read the safety instructions carefully before use.
Shop link: Preparing
Accessories
Specifications
| Parameter | Specs |
|---|---|
Charging Voltage | USB-5V (Type-C interface) |
Battery Capacity | 1300mAh |
Power | 8 - 15W |
Temp. Range | 300°C - 460°C |
Heating Time | 8 Seconds |
Sleep Time | 5 Minutes |
Resistance | 1.3 - 2.59Ω |
Instructions
Power On/Off
Install the soldering tip you would like to use, and press the button 5 times to turn on the device; press the button 5 times again to turn off the device (press continuously without a break)
Heat Up
After the device is turned on, press the power button to heat up the soldering iron, the heating will be stopped once the button is released. If you hold the Power Button for over 60 seconds, the battery will start the sleep mode (the light will flash in sleep mode). At this time, release the button and then press it again, normal heating will resume
Adjust Temperature
Press the button 3 times to switch between 3 adjustable levels.
Green light for low temperature (300°C)
Blue light for medium temperature (380°C)
Red light for the high temperature (460°C)
Continuous Heating Mode
Press the button twice to switch to continuous heating mode, this mode is for continuous operation for 5 minutes (can heat up to 400°C), so you don't need to heat up the tip manually (the light will keep breathing in this mode)
Charging
Type-C charging interface is located at the bottom of the device. There is a red indicator light in the charging state, and it will turn green when fully charged
Maintenance
It is important to note that the soldering tips provided are consumable items. Over time under normal usage, the plating on soldering iron tips will inevitably degrade. To ensure a continued optimal soldering experience, replaceable tips are readily available for purchase on our website
Safety Instructions
Keep the device out of the reach of children
Do not touch the soldering tip even if the device is not operating
Do not immerse the device in water
Do not operate the device with wet hands
Do not disassemble the device unless you are a trained professional
Refer all servicing to qualified personnel. Servicing is required when the device has been damaged in any way
Only use attachments/accessories specified by the manufacturer
Immediately turn off the switch if the device emits smoke, strange sounds or other anomalies
If damaged, stop use. If the functions alter or the device has been damaged in any way, please contact the retail outlet where the device was purchased
Dismantling or repairs must not be attempted at any time
Do not place the cables near a heating device. It may cause the device enclosure or components to melt. Do not leave the device in a car with closed windows, in direct sunlight, or in other places of extreme heat
If not using the device for a prolonged period, turn off the device and disconnect all attached cables
Ensure the device is set up on a stable surface
This device is not intended for use by persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the device by a person responsible for their safety
Last updated
